Detail JBL PRX 735 ACTIVE SPEAKER ( SPEAKER AKTIF )
ACTIVE SPEAKER ( SPEAKER AKTIF ) JBL PRX 735
15" Three-Way Full-Range Main System
The PRX735 is a self-powered, lightweight three-way loudspeaker system capable of delivering a very high level of performance over a broad bandwidth.
FEATURES :
136 dB peak SPL
15" Differential Drive® low-frequency driver for low-distortion and higher SPL
165 mm ( 6.5 in) horn loaded midrange transducer
1.5" diameter next generation JBL neodymium compression driver
JBL designed waveguide for accurate coverage
Efficient Class-D amplifier technology
Normal and Boost user selectable EQ presets
DSP input section, crossover, dynamic limiting, component optimization, selectable system EQ
Line level and direct microphone input capability
Professional XLR-1/ 4" combination inputs, RCA inputs, and XLR loop-through
Multiple injection molded handles with backing cup for easy transport
Integrated M10 suspension points for easy setup
Lightweight poplar plywood cabinets made structurally sound with tongue and groove joints and protected by JBL’ s tour proven DuraFlex™ finish.
Cloth backed, dent-resistant 16 gauge steel grilles
APPLICATIONS :
This speaker is ideally suited to applications where the program material exhibits subtlety and nuance. Perfectly capable of reproducing high fidelity full range sound without a subwoofer, when coupled with the extended low frequencies of the PRX718XLF, complete control over the entire audio spectrum is attained. As with all the full-range PRX700 Series systems, two EQ selections can be used to optimize the system for the program material and/ or environment. The input section also accommodates either Line or Mic/ Instrument level inputs.
The PRX735 is a self-powered, lightweight three-way loudspeaker system capable of delivering a very high level of performance over a wide bandwidth. The PRX735 is comprised of one 15 in 275G Differential Drive® woofer, a 165 mm ( 6.5 in) 196H horn-loaded mid-range and a 2408H-2 37.5 mm ( 1.5 in) annular polymer diaphragm, neodymium compression driver mounted to a 90° by 50° horn, all driven by a 1500 watt Audio Class-D power amplifier. Sophisticated DSP is at the core of a fully featured input section, providing user selectable system EQ, protection, input sensitivity selection, cross-over functionality, dynamic limiting and discrete component optimization.
All PRX700 cabinets are built from a combination of 25mm ( on the top and bottom for added rigidity) and 18mm, strong, light-weight poplar plywood made structurally sound with tongue and groove joints. All PRX700 Series cabinets are protected by JBL’ s tour proven DuraFlex™ finish. Grilles are made from dent-resistant 16 gauge steel and handles are made from light-weight glass-filled nylon for added strength and durability. All M10 suspension points are constructed from 14 gauge steel and have been tested with a yield-strength of
1000 lbs. each.
The amplifier input panel offers XLR or ¼ inch jack compatibility and a sensitivity switch provides extra flexibility, making it possible to connect literally any sound source without using a mixer. Signal present and overload lights indicate the system status and assist in setting the optimum level via the level control knob.
SPECIFICATIONS :
Power Rating 1500 W
Frequency Range ( -10 dB) Normal: 35 Hz – 20 kHz
Boost: 34 Hz – 20 kHz
Frequency Response ( ± 3 dB) Normal: 42 Hz – 20 kHz
Boost: 39 Hz – 20 kHz
Coverage Pattern 90° x 50° nominal
Directivity Index ( DI) 10.5 dB
Directivity Factor ( Q) 11.2
Crossover Frequency 480 Hz, 2.0 kHz
Maximum SPL Normal: 136dB
Boost: 136dB
Signal indicators Limit: Yellow LED indicates peak output has been reached and dsp
limiter is acting
Signal: Green LED indicates signal present
Power/ Standby: Blue indicates system has power and ready to pass audio,
Red indicates system has power but is in a power saving mode and will not
pass audio.
Dynamic Control ( Input) dbx Type IV™ limiter circuit
Input Impedance 20K Ohms ( balanced) , 10K Ohms ( unbalanced)
LF Driver 1 x JBL 275G 380mm ( 15 in) woofer
MF Driver 1 x JBL 196H 165mm ( 6.5 in) horn-loaded midrange transducer
HF Driver 1 x JBL 2408H-2 37.5 mm ( 1.5" ) annular polymer diaphragm, neodymium compression driver"
Enclosure Trapezoidal, 18 mm, plywood
Suspension / Mounting 12 x M10 Suspension Points
Transport 2 x integrated handle with injection molded backing cup
Finish Obsidian DuraFlex™ finish
Grille Powder coated, Obsidian, 16 gauge perforated steel with acoustical transparent black cloth backing.
Input Connectors 2 x Balanced XLR / 1/ 4 inch input, 2 x unbalanced RCA input
Output Connector 1 male XLR balanced output
Dimensions ( H x W x D) 952.5 mm x 445.0 mm x 537.97 mm
( 37.5 in x 17.52 in x 21.18 in)
Net Weight 34.9 kg ( 77 lb)
Tampilkan Lebih Banyak